MANUAL OF PETROLEUM MEASUREMENT STANDARDS - CHAPTER 14: NATURAL GAS FLUIDS MEASUREMENT - SECTION 8: LIQUEFIED PETROLEUM GAS MEASUREMENT
American Petroleum Institute
SECTION 8 - LIQUEFIED PETROLEUM GAS MEASUREMENT
1 SCOPE AND PURPOSE
2 REFERENCED PUBLICATIONS
3 APPLICATION
4 REQUIREMENTS FOR ALL MEASUREMENT METHODS
4.1 Provisions to Ensure That Fluids are in the Liquid Phase
4.2 Elimination of Swirl
4.3 Temperature Measurement
4.4 Pressure Measurement
4.5 Density or Relative Density Measurement
4.6 Location of Measuring and Sampling Equipment
5 VOLUMETRIC DETERMINATION IN DYNAMIC SYSTEMS
5.1 Measurement by Orifice Meter
5.2 Measurement by Positive Displacement Meter
5.3 Measurement by Turbine Meter
5.4 Measurement by Other Devices
5.5 Meter Proving
5.6 Sampling
5.7 Sample Analysis
6 MASS DETERMINATION IN DYNAMIC SYSTEMS
6.1 Base Conditions
6.2 Mass Measurement Using Displacement Type or Turbine Meters
6.3 Orifice Meters for Mass Measurement
6.4 Density Determination
6.5 Conversion of Measured Mass to Volume
7 VOLUMETRIC MEASUREMENT IN STATIC SYSTEMS
7.1 Tank Calibration
7.2 Tank Gauging of Liquefied Petroleum Gas
7.3 Temperature Measurement
7.4 Relative Density Measurement
7.5 Water and Foreign Material
7.6 Sampling
7.7 Volumetric Calculation
7.8 Mixture Calculation
8 MASS MEASUREMENT IN STATIC SYSTEMS
APPENDIX A COMPONENT SAMPLE CALCULATIONS
Figure
Table
Index
Outlines static and dynamic metering systems to measure gas in 0.350 to 0.637 grams per c.c. range. Serves as a guide in the selection, installation, operation, and maintenance of measuring systems that apply to liquefied petroleum gases and includes functional descriptions for individual systems. Coverage includes elimination of swirl, temperature measurement, pressure measurement, measurement by orifice meter, measurement by turbine meter, density determination, tank calibration, and special precautions for mass measurement.
| Document Type | Standard |
| Status | Current |
| Publisher | American Petroleum Institute |
| ProductNote | Reconfirmed 1997 |
