SAE J 1699-1 : 2006

Table of Contents

1 Scope
   1.1 Purpose
   1.2 Application
2 References
   2.1 Applicable Documents
        2.1.1 SAE Publications
   2.2 Related Publication
        2.2.1 SAE Publications
3 Definitions
4 Abbreviations and Acronyms
5 General Information
   5.1 Test Procedure Overview
        5.1.1 Invalid CRC Test
        5.1.2 Message Structure Test
        5.1.3 Bus Arbitration Test
        5.1.4 Bus Fault Test
        5.1.5 Symbol Parameter Limits
   5.2 Generic Test Conditions
        5.2.1 Digital Scope Requirements
        5.2.2 Power Supply Requirements
        5.2.3 Digital Volt Ohm Meter (DVOM)
               Requirements
        5.2.4 Ground Offset Voltage Device
        5.2.5 Small Signal Ground Offset Voltage Device
        5.2.6 VPW Bus RX/TX Circuit
        5.2.7 PWM Bus RX/TX Circuit
        5.2.8 PWM Scope Input Filter
        5.2.9 Network Access Device Requirements (NAD)
        5.2.10 Network Load Device for PWM and VPW

Abstract

Describes test methods, test procedures, and specific test parameters to help verify that vehicles and test tools can communicate using the SAE J1850. Also verifies the portion of SAE J1850 that is used for OBD-II communications.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	SAE International
Pages
ISBN