SAE J 2271 : 2009

Table of Contents

1 Scope
2 References
3 Definitions
4 Technical Requirements
5 Quality Assurance Requirements
6 Notes

Abstract

Describes dimensional and quality assurance requirements for 1/4 through 2 in sizes of studs in the following configurations in standard materials used for ship system applications: a. Continuous thread studs in UNRC and 8UNR series. b. Double end studs (clamping type) where both ends are of the same thread length (UNRC or 8UN). Also called bolt-studs. (These are suitable for mating with nuts or the set end may be installed with anaerobic thread locking compound.) c. Double end studs (interference thread type) with the nut end having UNRC or 8UNR series thread and where the tap end has NC 5 HFS interference fit thread forms.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	SAE International
Pages
ISBN