SAE J 2596 : 2013
SAE J 2596 : 2013
FASTENER PART STANDARD - TAPPING SCREWS AND METALLIC DRIVE SCREWS (INCH DIMENSIONED)
SAE International
Table of Contents
1. SCOPE
2. REFERENCES
3. DEFINITIONS
4. TAPPING SCREW REQUIREMENTS
5. NOTES
APPENDIX A - OTHER TAPPING SCREW STANDARDS
Abstract
Describes selected inch dimensioned tapping screws and metallic drive screws manufactured in accordance with American Society for Mechanical Engineers dimensional standards.
General Product Information
| Document Type | Standard |
| Status | Current |
| Publisher | SAE International |
Cart
(empty)
New products
- EIA-364-79 1998 R2015
- ECIA EIA-364-114:2010 R2017
- ECIA EIA-364-78C
- IEC 62908-12-10 Ed. 2.0 en:2023
- IEC 62471-7 Ed. 1.0 b:2023
- IEC 62087-3 Ed. 2.0 b:2023
- IEC 60332-SER Ed. 1.0 b:2023
- IEC 61970-SER Ed. 1.0 b:2023
- IEC 61158-5-4 Ed. 4.0 b:2023
- IEC 61784-1-3 Ed. 1.0 b:2023
- IEC 61784-1-0 Ed. 1.0 b:2023
- IEC 62769-150-1 Ed. 2.0 b:2023
- IEC 61784-2-21 Ed. 1.0 b:2023
- IEC 63171-7 Ed. 1.0 en:2023
- IEC 63474 Ed. 1.0 b:2023
- IEC 60534-1 Ed. 4.0 b:2023
- IEC 62106-6 Ed. 2.0 en:2023
- IEC 60601-2-46 Ed. 4.0 b:2023
- IEC 60071-2 Ed. 5.0 b:2023
- IEC 61156-11 Ed. 2.0 en:2023