MATERIALS FOR PRINTED BOARDS AND OTHER INTERCONNECTING STRUCTURES - SECTIONAL SPECIFICATION SET FOR UNREINFORCED BASE MATERIALS, CLAD AND UNCLAD (INTENDED FOR FLEXIBLE PRINTED BOARDS) - ADHESIVE COATED FLEXIBLE POLYESTER FILM
International Electrotechnical Committee
FOREWORD
1 Scope
2 Normative references
3 Materials and construction
4 Internal marking
5 Designation
6 Properties of adhesive coated polyester films
7 Dimensions and tolerances
8 Packaging and marking
9 Acceptance testing
Annex A (informative) Conversion table for test method
reference numbers
Gives requirements for flexible polyester (PETP) films coated on one or both sides with polyester, acrylic or epoxide type adhesive for use in fabricating flexible printed wiring. Films coated on only one side are used as a cover-lay or cover-coat in the fabrication of flexible printed wiring. This coverlay or covercoat is also used to provide local support to areas subjected to mechanical or environmental stress. Films coated on both sides are used as bonding films in the fabrication of printed boards.
| Document Type | Standard |
| Status | Current |
| Publisher | International Electrotechnical Committee |
| Committee | TC 52 |
