ELECTROMECHANICAL COMPONENTS FOR ELECTRONIC EQUIPMENT; BASIC TESTING PROCEDURES AND MEASURING METHODS - MISCELLANEOUS TESTS
International Electrotechnical Committee
Contents
Foreword
Introduction
Clause
SECTION ZERO: GENERAL
0.1 Scope
0.2 Normative references
SECTION ONE: CABLE CLAMPING TESTS
1. Test 17a: Cable clamp robustness
2. Test 17b: Cable clamp resistance to cable rotation
3. Test 17c: Cable clamp resistance to cable pull (tensile)
4. Test 17d: Cable clamp resistance to cable torsion
SECTION TWO: EXPLOSION HAZARD TESTS
5. Test 18a: Explosion hazard (deleted)
SECTION THREE: CHEMICAL RESISTANCE TESTS
6. Test 19a: Fluid resistance of pre-insulated crimp barrels
7. Test 19b: Resistance to ozone (deleted)
SECTION FOUR: FIRE HAZARD TESTS
8. Test 20a: Flammability, needle-flame
9. Test 20b: Fireproofness (under consideration)
10. Test 20c: Flammability, glow-wire
SECTION FIVE: R.F. RESISTANCE TESTS
11. Test 21a: R.F. shunt resistance
SECTION SIX: CAPACITANCE TESTS
12. Test 22a: Capacitance
SECTION SEVEN: SHIELDING AND FILTERING TESTS
13. Test 23a: Screening effectiveness (under consideration)
14 Test 23b: Suppression characteristics of integral filters
15. Test 23c: Crosstalk (deleted)
SECTION EIGHT: MAGNETIC INTERFERENCE TESTS
16. Test 24a: Residual magnetism
17. Test 24b: Magnetic influence of a component on a compass
(deleted)
Contains tests for cable clamping, r.f. resistance and capacitance. All other tests are still under consideration. Contains the following sections: Cable Clamping Tests, Explosion Hazard Tests, Chemical Resistance Tests, Fire Hazard Tests, R.F. Resistance Tests, Capacitance Tests, Shielding and Filtering Tests and Magnetic Interference Tests.
| Document Type | Standard |
| Status | Current |
| Publisher | International Electrotechnical Committee |
| Committee | TC 48 |
