METHODS OR MEASUREMENT FOR RADIO EQUIPMENT USED IN THE MOBILE SERVICES - PART 2: TRANSMITTERS EMPLOYING A3E, F3E OR G3E EMISSIONS
International Electrotechnical Committee
FOREWORD
PREFACE
SECTION ONE - GENERAL, SUPPLEMENTARY DEFINITIONS AND
CONDITIONS OF MEASUREMENT
1 Scope
2 Object
3 Supplementary terms and definitions
4 Standard test conditions
5 Supplementary test conditions
6 Characteristics of the measuring equipment
SECTION TWO - METHODS OF MEASUREMENT
7 Frequency error
8 Terminal radio-frequency power
9 Radiated radio-frequency power
10 Input power and overall efficiency
11 Inter-transmitter intermodulation
12 Modulation characteristic
13 Modulation sensitivity
14 Total distortion factor
15 Relative audio-frequency intermodulation product level
16 Compressor characteristics
17 Modulation limiting
18 Residual modulation (due to hum and noise)
19 Transmitter attach time
20 Transmitter performance under conditions deviating from
standard test conditions
APPENDIX A - Recommended characteristics of the measuring
equipment
APPENDIX B - Example of a main power lime impedance
stabilization network
Gives the definitions, the conditions and the methods of measurement used to ascertain the performance of transmitters and to make possible a meaningful comparison of the results of measurements made by different observers and on different equipment.
| Document Type | Standard |
| Status | Current |
| Publisher | International Electrotechnical Committee |
| Committee | TC 12 |
| Supersedes |
|
