SPECIFICATIONS FOR PARTICULAR TYPES OF WINDING WIRES - PART 0-5: GENERAL REQUIREMENTS - GLASS-FIBRE BRAIDED, RESIN OR VARNISH IMPREGNATED, BARE OR ENAMELLED RECTANGULAR COPPER WIRE
International Electrotechnical Committee
FOREWORD<br>INTRODUCTION<br>1 Scope<br>2 Normative references <br>3 Definitions, general notes on methods of test and <br> appearance <br> 3.1 Definitions <br> 3.2 General notes on methods of test <br> 3.3 Appearance<br>4 Dimensions<br> 4.1 Conductor dimensions<br> 4.2 Tolerance on conductor dimensions <br> 4.3 Rounding of corners <br> 4.4 Increase in dimensions due to the insulation <br> 4.5 Overall dimensions<br>5 Electrical resistance <br>6 Elongation<br>7 Springiness<br>8 Flexibility and adherence<br> 8.1 Mandrel winding test <br> 8.2 Adherence test <br>9 Heat shock<br>10 Cut-through <br>11 Resistance to abrasion <br>12 Resistance to solvents <br>13 Breakdown voltage <br>14 Continuity of insulation <br>15 Temperature index <br>16 Resistance to refrigerants<br>17 Solderability<br>18 Heat or solvent bonding <br>19 Dielectric dissipation factor<br>20 Resistance to transformer oil <br>21 Loss of mass <br>23 Pin hole test <br>30 Packaging <br>Annex A (informative) Nominal cross-sectional areas for <br> preferred and intermediate sizes
Specifies general requirements of glass-fibre braided resin or varnish impregnated, bare or enamelled rectangular copper wire.
| Document Type | Standard |
| Status | Current |
| Publisher | International Electrotechnical Committee |
| Committee | TC 55 |
