SPECIFICATIONS FOR PARTICULAR TYPES OF WINDING WIRES - POLYESTER OR POLYESTERIMIDE OVERCOATED WITH POLYAMIDE-IMIDE ENAMELLED RECTANGULAR COPPER WIRE, CLASS 200
International Electrotechnical Committee
FOREWORD<br>INTRODUCTION<br>1 Scope<br>2 Normative references<br>3 Definitions and general notes on methods of test and <br> appearance<br>4 Dimensions<br>5 Electrical resistance<br>6 Elongation<br>7 Springiness<br>8 Flexibility and adherence<br>9 Heat shock<br>10 Cut-through<br>11 Resistance to abrasion<br>12 Resistance to solvents<br>13 Breakdown voltage<br>14 Continuity of insulation<br>15 Temperature index<br>16 Resistance to refrigerants<br>17 Solderability<br>18 Heat or solvent bonding<br>19 Dielectric dissipation factor<br>20 Resistance to transformer oil<br>21 Loss of mass<br>22 High temperature failure<br>23 Pin hole test<br>30 Packaging
Defines the requirements of enamelled rectangular copper winding wire of class 200 with a dual coating. The underlying coating is based on polyester or polyesterimide resin, which may be modified providing it retains the chemical identity of the original resin and meets all specified wire requirements. The superimposed coating is based on polyamide-imide resin.
| Document Type | Standard |
| Status | Current |
| Publisher | International Electrotechnical Committee |
| Committee | TC 55 |
