SPECIFICATIONS FOR PARTICULAR TYPES OF WINDING WIRES - PART 0-4: GENERAL REQUIREMENTS - GLASS-FIBRE WOUND, RESIN OR VARNISH IMPREGNATED, BARE OR ENAMELLED RECTANGULAR COPPER WIRE
International Electrotechnical Committee
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms, definitions and general notes
on tests and appearance
4 Dimensions
5 Electrical resistance
6 Elongation
7 Springiness
8 Flexibility and adherence
9 Heat shock
10 Cut-through
11 Resistance to abrasion
12 Resistance to solvents
13 Breakdown voltage
14 Continuity of insulation
15 Temperature index
16 Resistance to refrigerants
17 Solderability
18 Heat or solvent bonding
19 Dielectric dissipation factor
20 Resistance to transformer oil
21 Loss of mass
23 Pin hole test
30 Packaging
Annex A (informative) - Nominal cross-sectional
areas for preferred and intermediate
sizes
Bibliography
Defines general requirements of glass-fibre wound, resin or varnish impregnated, bare or enamelled rectangular copper wire.
| Document Type | Standard |
| Status | Current |
| Publisher | International Electrotechnical Committee |
| Committee | TC 55 |
