SPECIFICATIONS FOR PARTICULAR TYPES OF WINDING WIRES - PART 0-1: GENERAL REQUIREMENTS - ENAMELLED ROUND COPPER WIRE
International Electrotechnical Committee
FOREWORD<br>INTRODUCTION<br>1 Scope<br>2 Normative references<br>3 Terms, definitions, general notes and <br> appearance<br>4 Dimensions<br>5 Electrical resistance<br>6 Elongation<br>7 Springiness<br>8 Flexibility and adherence<br>9 Heat shock<br>10 Cut-through<br>11 Resistance to abrasion<br>12 Resistance to solvents<br>13 Breakdown voltage<br>14 Continuity of insulation (nominal conductor <br> diameters up to and including 1,600 mm)<br>15 Temperature index<br>16 Resistance to refrigerants<br>17 Solderability <br>18 Heat or solvent bonding <br>19 Dielectric dissipation factor<br>20 Resistance to transformer oil <br>21 Loss of mass <br>23 Pin hole test<br>30 Packaging<br>Annex A (informative) - Dimensions for intermediate <br> nominal conductor diameters (R 40)<br>Annex B (informative) - Method for the calculation <br> of linear resistance <br>Annex C (informative) - Resistance<br>Bibliography
Defines general requirements of enamelled round copper winding wires with or without bonding layer.
| Document Type | Standard |
| Status | Current |
| Publisher | International Electrotechnical Committee |
| Committee | TC 55 |
