SAFETY IN ELECTROHEAT INSTALLATIONS - PART 3: PARTICULAR REQUIREMENTS FOR INDUCTION AND CONDUCTION HEATING AND INDUCTION MELTING INSTALLATIONS
International Electrotechnical Committee
FOREWORD
1 Scope
2 Normative references
3 Terms and definitions
4 Heating inductor
5 Capacitors
6 Mains frequency power sources
7 Solid-state frequency converters
8 Switchgear
9 Cables, wires and busbars
10 Liquid cooling
11 Rating plate
12 Clearance and creepage distances
13 Protection against electric shock
13.1 Protection against direct contact
13.2 Protection against indirect contact
13.3 Special requirements
13.4 Earthing provisions
13.5 Protective conductors
14 Radio interferences
Annex A (normative) Specific requirements for induction and
conduction heating installations
Annex B (normative) Specific requirements for induction
melting installations
Applies to: - installations for induction and conduction heating of solids, at low, medium and high frequencies. (For conduction heating, use of direct current is also included); - installations for induction melting, holding and superheating at low, medium and high frequencies; - those parts of the conveying or handling equipment of the electroheat installation which are within the influence of the heating section.
| Document Type | Standard |
| Status | Current |
| Publisher | International Electrotechnical Committee |
| Committee | TC 27 |
