METHODS OF MEASUREMENT FOR RADIO EQUIPMENT USED IN SATELLITE EARTH STATIONS. PART 2: MEASUREMENTS FOR SUB-SYSTEMS. SECTION SEVEN: HIGH-POWER AMPLIFIER
International Electrotechnical Committee
FOREWORD
PREFACE
SECTION SEVEN: HIGH POWER AMPLIFIER
Clause
1. Scope
2. Input and output power
3. Return loss
4. Power gain
5. Spurious signals
6. Output power
7. Efficiency
8. Amplitude/frequency characteristic
9. Group-delay/frequency characteristic
10. Residual modulation
11. Amplitude modulation/phase modulation conversion factor
12. Multi-carrier intermodulation ratio
13. Noise figure
14. Automatic levelling control (a.l.c)
15. Gain stability
16. Ionizing radiation
17. Stray r.f. emission (cabinet radiation)
Figures
Defines and describes the measurements normally made on high-power amplifiers used in satellite earth station transmitters.
| Document Type | Standard |
| Status | Current |
| Publisher | International Electrotechnical Committee |
| Committee | SC 12E |
