MICROPROCESSOR SYSTEM BUS, 8-BIT AND 16-BIT DATA (MULTIBUS I) - MECHANICAL AND PIN DESCRIPTIONS FOR THE SYSTEM BUS CONFIGURATION, WITH EDGE CONNECTORS (DIRECT)
International Electrotechnical Committee
FOREWORD
PREFACE
INTRODUCTION
MECHANICAL SPECIFICATIONS
Clause
1 Scope
2 Object
3 Backplane considerations
3.1 Board to board relationships
3.2 System bus pin assignments
3.3 Bus connectors
4 Form factors
4.1 Connector naming and pin numbering standards
4.2 Standard outline of printed wiring boards
Applies to an interface used to connect microprocessor system components by means of edge connector (direct) type backplane. Describes all the physical and mechanical specifications required for designing a backplane or for designing printed circuit boards that will plug into the system bus interface. All dimensions are in millimeters with inches in parentheses for reference only.
| Document Type | Standard |
| Status | Current |
| Publisher | International Electrotechnical Committee |
| Committee | JTC1/SC 26 |
