SAE MA 1573 : 2016

Table of Contents

1. SCOPE
2. APPLICABLE DOCUMENTS
3. TECHNICAL REQUIREMENTS
4. QUALITY ASSURANCE PROVISIONS
5. PREPARATION FOR DELIVERY
6. ACKNOWLEDGEMENT
7. REJECTIONS
8. NOTES
APPENDIX A - MEASUREMENT OF PERPENDICULARITY VARIATION OF THE
             BEARING SURFACE
APPENDIX B - WRENCH TORQUE TEST
APPENDIX C - PUSH-OUT TEST
APPENDIX D - TORQUE-OUT TEST
APPENDIX E - PERMANENT SET TEST
APPENDIX F - REUSABILITY TEST AT ROOM TEMPERATURE, AFTER BAKING
APPENDIX G - REUSABILITY TEST AT ROOM TEMPERATURE, AT RECEIVED
             CONDITION
APPENDIX H - THREE-CYCLE TEST AT ROOM TEMPERATURE
APPENDIX J - ACCEPTANCE CRITERIA OF SURFACE DISCONTINUITIES ON
             SELF-LOCKING NUTS

Abstract

Describes the requirements for the following types of self-locking nuts: a. Wrenching nuts: that is, hex, double hex, spline drive b. Anchor nuts: that is, plate nuts, gang channel nuts, shank nuts.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	SAE International
Pages
ISBN
Committee	E-25