IEC 61610 : 1.0

Table of Contents

FOREWORD
Clause
1 Scope
2 Normative references
3 Terms and definitions
4 Conditions
   4.1 Environmental conditions
   4.2 Conditions of measurement
   4.3 Conditions of calculation
5 Methods of measurements
   5.1 Gamut of colours
   5.2 Reproduced colours
   5.3 Colour rendering
   5.4 Grey balance
   5.5 Grey scale reproduction (tone reproduction)
   5.6 Grey non-uniformity
   5.7 Resolution
   5.8 Image stability under exposure to light
        (light fastness)
   5.9 Image stability under exposure to heat
        (heat fastness)
   5.10 Reproducible dimensional range
   5.11 Flat field modulation
   5.12 Contouring
   5.13 Spatial linearity
   5.14 Misregistration
Annexes
A Specification of the input signal for the measurement
   of reproduced colours
B Bibliography

Abstract

Applies to the assessment of image attribution on prints and transparencies produced from electronic sources. Specifies test signals, measurement conditions and forms of reporting the results so as to make possible comparison of the results of measurement. Applicable to a wide quality range of colour prints and transparencies.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	International Electrotechnical Committee
Pages
ISBN
Committee	TC 100