ELECTRICAL INSULATION SYSTEMS - PROCEDURES FOR THERMAL EVALUATION - PART 22: SPECIFIC REQUIREMENTS FOR ENCAPSULATED-COIL MODEL - WIRE-WOUND ELECTRICAL INSULATION SYSTEM (EIS)
International Electrotechnical Committee
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Construction
4.1 General information
4.2 ECM components
4.3 Assembly of the ECM
4.4 Similarity of reference and candidate ECM
5 Number of test objects
6 Test procedure
6.1 General
6.2 Initial screening test
6.2.1 General
6.2.2 Initial dielectric test
6.3 Thermal endurance test
6.3.1 Endurance test cycle
6.3.2 Thermal ageing
6.3.3 Mechanical stress
6.3.4 Thermal shock
6.3.5 Moisture exposure
6.3.6 Dielectric diagnostic test
7 End-of-life criterion
8 Analysing, reporting and classification
Annex A (informative) Similarity of reference and
candidate specimens
Bibliography
Provides a general-purpose procedure for the evaluation of wire-wound systems using a general purpose encapsulated-coil model (ECM) where the application is unknown.
| Document Type | Standard |
| Status | Current |
| Publisher | International Electrotechnical Committee |
| Committee | TC 112 |
