ELECTRICITY METERING (A.C.) - TARIFF AND LOAD CONTROL - PART 11: PARTICULAR REQUIREMENTS FOR ELECTRONIC RIPPLE CONTROL RECEIVERS
International Electrotechnical Committee
FOREWORD<br>INTRODUCTION<br>INTRODUCTION TO AMENDMENT 1<br>1 Scope<br>2 Normative references<br>3 Terms and definitions<br>4 Standard electrical values<br>5 Mechanical requirements and tests<br>6 Climatic conditions, requirements and tests<br>7 Electrical requirements and tests<br>8 Test conditions and type test<br>Annex A (normative) - Harmonic levels for testing<br> ripple control receivers<br>Annex B (normative) - Selection of frequency for<br> tests with harmonics<br>Annex C (normative) - Combination of parameters<br> for operation and non-operation tests <br>Annex D (informative) - Acceptance tests<br>Annex E (informative) - Code terms<br>Annex F (informative) - Example of a test<br> configuration for operation and non operation<br> tests and for measurement of disturbance-limit<br> curves<br>Annex G (informative) - Values of the influence<br> quantities for the different tests
Describes particular requirements for the type test of newly manufactured indoor electronic ripple control receivers for the reception and interpretation of pulses of a single audio frequency superimposed on the voltage of the electricity distribution network and for the execution of the corresponding switching operations.
| Document Type | Standard |
| Status | Current |
| Publisher | International Electrotechnical Committee |
| Committee | TC 13 |
