MECHANICAL STRUCTURES FOR ELECTRONIC EQUIPMENT - DIMENSIONS OF MECHANICAL STRUCTURES OF THE 482,6 MM (19 IN) SERIES - PART 3-102: INJECTOR/EXTRACTOR HANDLE
International Electrotechnical Committee
FOREWORD
INTRODUCTION
1 Scope and object
2 Normative references
3 Terms and definitions
4 Arrangement overview of front panel mounted
injector/extractor handle Type A
5 Subrack interface dimensions for front panel mounted
injector/extractor, Type A
6 Plug-in unit interface dimensions for front panel
mounted injector/extractor handle Type A
7 Arrangement overview of printed board mounted
injector/extractor handle Type B
8 Subrack interface dimensions for printed board mounted
injector/extractor handle, Type B
9 Printed board mounted injector/extractor interface
dimensions handle, Type B
10 Dimensions used in the figures
Describes only the additional interface dimensions for injector/extractor devices used with subracks and plug-in units according to IEC 60297-3-101.
| Document Type | Standard |
| Status | Current |
| Publisher | International Electrotechnical Committee |
| Committee | TC 48 |
