IEC 61204-7 : 2.0

LOW-VOLTAGE SWITCH MODE POWER SUPPLIES - PART 7: SAFETY REQUIREMENTS

International Electrotechnical Committee

More details

More info

FOREWORD
INTRODUCTION
0 Principles of safety
1 Scope
2 Normative references
3 Terms and definitions
4 Protection against hazards
5 Test requirements
6 Information and marking requirements
7 Components
Annex A (normative) - Additional information for
        protection against electric shock
Annex B (informative) - Considerations for the
        reduction of the pollution degree
Annex C (informative) - Symbols referred to in
        IEC 62477-1
Annex D (normative) - Evaluation of clearance and
        creepage distances
Annex E (informative) - Altitude correction for
        clearances
Annex F (normative) - Clearance and creepage
        distance determination for frequencies
        greater than 30 kHz
Annex G (informative) - Cross-sections of round
        conductors
Annex H (informative) - Guidelines for RCD
        compatibility
Annex I (informative) - Examples of overvoltage
        category reduction
Annex J (informative) - Burn thresholds for
        touchable surfaces
Annex K (informative) - Table of electrochemical
        potentials
Annex L (informative) - Measuring instrument for
        touch current measurements
Annex M (informative) - Test probes for determining
        access
Annex AA (normative) - Addition Insulated winding
         wires for use without interleaved insulation
Annex AB (informative) - Minimum and maximum
         cross-section of copper conductors suitable
         for connection to terminals for external
         conductors
Annex AC (normative) - DC power and distribution
         equipment
Annex AD (informative) - Addition Examples of
         protective measures according to IEC 61204-7
         clause 4.4.1 - 4.4.5 for protection against
         electrical shock
Bibliography

Abstract

Describes the safety requirements for switch mode power supply (SMPS) units supplied by source voltages up to 1000 V AC or 1500 V DC providing AC and/or DC output(s), except inverter output(s) establishing AC mains.