CONNECTORS FOR ELECTRONIC EQUIPMENT - PRODUCT REQUIREMENTS - PART 2-105: CIRCULAR CONNECTORS - DETAIL SPECIFICATION FOR M5 CONNECTORS WITH SCREW-LOCKING
International Electrotechnical Committee
FOREWORD
1 General information
1.1 Scope
1.2 Recommended method of termination
1.2.1 Number of contacts or contact cavities
1.3 Ratings and characteristics
1.4 Normative references
1.5 Marking
1.6 IEC type designation
1.7 Ordering information
1.8 Safety aspects
2 Technical information
2.1 Terms and definitions
2.2 Survey of styles and variants
2.2.1 Fixed connectors
2.2.2 Free connectors
3 Dimensions
3.1 General
3.2 Interface dimensions
3.2.1 Pin front view
3.3 Gauges
4 Characteristics
4.1 Climatic category
4.2 Electrical
4.2.1 Rated voltage - Rated impulse voltage - Pollution
degree
4.2.2 Voltage proof
4.2.3 Current-carrying capacity
4.2.4 Contact resistance
4.2.5 Insulation resistance
4.3 Mechanical
4.3.1 IP degree of protection
4.3.2 Mechanical operation
4.3.3 Insertion and withdrawal forces
4.3.4 Contact retention in insert
4.3.5 Polarizing method
4.3.6 Vibration (sinusoidal)
5 Test schedule
5.1 General
5.1.1 Arrangement for contact resistance measurements
5.1.2 Arrangement for dynamic stress tests (vibration)
5.2 Test schedule
5.2.1 Test group P - Preliminary
5.2.2 Test group AP - Dynamic/ climatic
5.2.3 Test group BP - Mechanical endurance
5.2.4 Test group CP - Electrical load
5.2.5 Test group DP - Chemical resistivity
5.2.6 Test group EP - Connection method tests
Annex A (informative) Diameter of the female connector
body
Bibliography
Describes circular connectors with M5 screw-locking, typically used for industrial process measurement and control.
| Document Type | Standard |
| Status | Current |
| Publisher | International Electrotechnical Committee |
| Committee | TC 48 |
