ALARM SYSTEMS - INTRUSION AND HOLD-UP SYSTEMS - PART 2-2: INTRUSION DETECTORS - PASSIVE INFRARED DETECTORS
International Electrotechnical Committee
FOREWORD<br>INTRODUCTION<br>1 Scope<br>2 Normative references<br>3 Terms, definitions and abbreviations<br>4 Functional requirements<br>5 Marking, identification and documentation<br>6 Testing<br>Annex A (normative) - Dimensions and requirements of<br> the standardised test magnets<br>Annex B (normative) - General testing matrix<br>Annex C (informative) - Walk test diagrams<br>Annex D (normative) - Procedure for calculation of<br> average temperature difference<br>Annex E (informative) - Basic detection target for the<br> basic test of detection capability<br>Annex F (informative) - Equipment for walk test velocity<br> control<br>Annex G (informative) - Immunity to visible and near<br> infrared radiation - Notes on calibration of <br> the light source<br>Annex H (informative) - Example list of small tools<br>Annex I (informative) - Test for resistance to re-orientation <br> of adjustable mountings<br>Bibliography
Applies to passive infrared detectors installed in buildings and provides for security grades 1 to 4, specific or non-specific wired or wire-free detectors, and uses environmental classes I to IV.
| Document Type | Standard |
| Status | Current |
| Publisher | International Electrotechnical Committee |
| Committee | TC 79 |
| Supersedes |
|
