ALARM SYSTEMS - INTRUSION AND HOLD-UP SYSTEMS - PART 2-5: INTRUSION DETECTORS - COMBINED PASSIVE INFRARED/ULTRASONIC DETECTORS
International Electrotechnical Committee
FOREWORD<br>INTRODUCTION<br>1 Scope<br>2 Normative references<br>3 Terms, definitions and abbreviations<br>4 Functional requirements<br>5 Marking, identification and documentation<br>6 Testing<br>Annex A (normative) - Dimensions and requirements of the<br> standardised test magnets<br>Annex B (normative) - General testing matrix<br>Annex C (informative) - Walk test diagrams<br>Annex D (normative) - Procedure for calculation of average <br> temperature difference<br>Annex E (informative) - Basic detection target for the basic <br> test of detection capability<br>Annex F (informative) - Equipment for walk test velocity control<br>Annex G (informative) - Immunity to visible and near infrared <br> radiation - Notes on calibration of the light source<br>Annex H (informative) - Example list of small tools<br>Annex I (informative) - Test for resistance to re-orientation of <br> adjustable mountings<br>Bibliography
Applies to combined passive infrared and ultrasonic detectors installed in buildings and provides for security grades 1 to 4, specific or non-specific wired or wire-free detectors, and uses environmental classes I to IV.
| Document Type | Standard |
| Status | Current |
| Publisher | International Electrotechnical Committee |
| Committee | TC 79 |
| Supersedes |
|
