PLUGS, SOCKET-OUTLETS, VEHICLE CONNECTORS AND VEHICLE INLETS - CONDUCTIVE CHARGING OF ELECTRIC VEHICLES - PART 2: DIMENSIONAL COMPATIBILITY AND INTERCHANGEABILITY REQUIREMENTS FOR A.C. PIN AND CONTACT-TUBE ACCESSORIES
International Electrotechnical Committee
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 General
5 Ratings
6 Connection between the power supply and the electric vehicle
7 Classification of accessories
8 Marking
9 Dimensions
10 Protection against electric shock
11 Size and colour of protective earthing conductors
12 Provision for earthing
13 Terminals
14 Interlocks
15 Resistance to ageing of rubber and thermoplastic material
16 General construction
17 Construction of socket-outlets
18 Construction of plugs and vehicle connectors
19 Construction of vehicle inlets
20 Degrees of protection
21 Insulation resistance and dielectric strength
22 Breaking capacity
23 Normal operation
24 Temperature rise
25 Flexible cables and their connection
26 Mechanical strength
27 Screws, current-carrying parts and connections
28 Creepage distances, clearances and distances
29 Resistance to heat, to fire and to tracking
30 Corrosion and resistance to rusting
31 Conditional short-circuit current withstand test
32 Electromagnetic compatibility (EMC)
33 Vehicle driveover
201 Components
202 Resistor coding
STANDARD SHEETS
Pertains to plugs, socket-outlets, vehicle connectors and vehicle inlets with pins and contact-tubes of standardized configurations, herein referred to as accessories.
| Document Type | Standard |
| Status | Current |
| Publisher | International Electrotechnical Committee |
| Committee | TC 23 |
