SPECIFICATIONS FOR PARTICULAR TYPES OF WINDING WIRES - PART 56: SOLDERABLE FULLY INSULATED (FIW) ZERO-DEFECT POLYURETHANE ENAMELLED ROUND COPPER WIRE, CLASS 180
International Electrotechnical Committee
FOREWORD<br>INTRODUCTION<br>1 Scope <br>2 Normative references <br>3 Terms and definitions, general notes and appearance<br>4 Dimensions<br>5 Electrical resistance <br>6 Elongation<br>7 Springiness<br>8 Flexibility and adherence<br>9 Heat shock <br>10 Cut-through<br>11 Resistance to abrasion (for nominal diameters of<br> 0,250 mm up to and including 0,900 mm)<br>12 Resistance to solvents<br>13 Breakdown voltage <br>14 Continuity of insulation <br>15 Temperature index <br>16 Resistance to refrigerants <br>17 Solderability <br>18 Heat or solvent bonding<br>19 Dielectric dissipation factor <br>20 Resistance to transformer oil<br>21 Loss of mass<br>23 Pin-hole test <br>30 Packaging<br>Annex A (informative) - Resistance to abrasion <br>Bibliography
Describes the requirements of solderable fully insulated (FIW) zero-defect enamelled round copper wire, class 180, with a single coating based on polyurethane resin, which may be modified providing it retains its chemical identity and satisfies all the required technical specifications.
| Document Type | Standard |
| Status | Current |
| Publisher | International Electrotechnical Committee |
| Committee | TC 55 |
