SAFETY OF TRANSFORMERS, REACTORS, POWER SUPPLY UNITS AND SIMILAR PRODUCTS FOR SUPPLY VOLTAGES UP TO 1100 V - PART 2-16: PARTICULAR REQUIREMENTS AND TESTS FOR SWITCH MODE POWER SUPPLY UNITS AND TRANSFORMERS FOR SWITCH MODE POWER SUPPLY UNITS
International Electrotechnical Committee
FOREWORD
INTRODUCTION TO THE AMENDMENT
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 General notes on tests
6 Ratings
7 Classification
8 Marking and other information
9 Protection against electric shock
10 Change of input voltage setting
11 Output voltage and output current under load
12 No-load output voltage
13 Short circuit voltage
14 Heating
15 Short-circuit and overload protection
16 Mechanical strength
17 Protection against harmful ingress of dust,
solid objects and moisture
18 Insulation resistance, dielectric strength
and leakage current
19 Construction
20 Components
21 Internal wiring
22 Supply connection and other external flexible
cables or cords
23 Terminals for external conductors
24 Provisions for protective earthing
25 Screws and connections
26 Creepage distances, clearances and distances
through insulation
27 Resistance to heat, fire and tracking
28 Resistance to rusting
Annexes
Annex K (normative) - Insulated winding wires
Annex AA (informative) - Partial discharge (PD) test
Annex BB (normative) - Particular requirements
for associated transformers for use in switch
mode power supplies with internal frequencies > 500 Hz
Bibliography
Specifies the safety of switch mode power supply units and transformers for switch mode power supply units.
| Document Type | Standard |
| Status | Current |
| Publisher | International Electrotechnical Committee |
| Committee | TC 96 |
