PLUGS, SOCKET-OUTLETS, VEHICLE CONNECTORS AND VEHICLE INLETS - CONDUCTIVE CHARGING OF ELECTRIC VEHICLES - PART 3: DIMENSIONAL COMPATIBILITY AND INTERCHANGEABILITY REQUIREMENTS FOR D.C. AND A.C./D.C. PIN AND CONTACT-TUBE VEHICLE COUPLERS
International Electrotechnical Committee
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 General
5 Ratings
6 Connection between the power supply and the electric vehicle
7 Classification of accessories
8 Marking
9 Dimensions
10 Protection against electric shock
11 Size and colour of earthing conductors
12 Provision for earthing
13 Terminals
14 Interlocks
15 Resistance to aging of rubber and thermoplastic material
16 General construction
17 Construction of socket-outlets
18 Construction of plugs and vehicle connectors
19 Construction of vehicle inlets
20 Degrees of protection
21 Insulation resistance and dielectric strength
22 Breaking capacity
23 Normal operation
24 Temperature rise
25 Flexible cables and their connection
26 Mechanical strength
27 Screws, current-carrying parts and connections
28 Creepage distances, clearances and distances
29 Resistance to heat, to fire and to tracking
30 Corrosion and resistance to rusting
31 Conditional short-circuit current withstand test
32 Electromagnetic compatibility
33 Vehicle driveover
Bibliography
Pertains to vehicle couplers with pins and contact-tubes of standardized configuration, herein also referred to as 'accessories', intended for use in electric vehicle conductive charging systems which incorporate control means, with rated operating voltage up to 1500 V d.c. and rated current up to 250 A, and 1000 V a.c. and rated current up to 250 A.
| Document Type | Standard |
| Status | Current |
| Publisher | International Electrotechnical Committee |
| Committee | TC 23 |
