AC AND/OR DC-SUPPLIED ELECTRONIC CONTROLGEAR FOR DISCHARGE LAMPS (EXCLUDING FLUORESCENT LAMPS) - PERFORMANCE REQUIREMENTS FOR LOW FREQUENCY SQUARE WAVE OPERATION
International Electrotechnical Committee
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 General notes on tests
5 Marking
6 General statement
7 Starting conditions
8 Operating conditions
9 Displacement factor
10 Supply current
11 Endurance
Annex A (normative) - Tests
Annex B (normative) - Reference ballasts
Annex C (normative) - Conditions for reference lamps
Annex D (normative) - Control interface for controllable
controlgear
Annex E (normative) - Spectral analysis of power ripple:
calculation procedure for amplitude spectrum
ratio and guidance
Annex F (normative) - Open circuit voltage method of measurement
for pulse ignition
Bibliography
Defines performance requirements for electronic controlgear for use on a.c. and/or d.c. supplies up to 1000 V and/or a.c. supplies up to 1000 V at 50 Hz or 60 Hz, associated with discharge lamps, as specified in IEC 61167, which have information for low frequency square wave operation, where the frequency range of the low frequency is from 70 Hz to 400 Hz.
| Document Type | Standard |
| Status | Current |
| Publisher | International Electrotechnical Committee |
| Committee | TC 34 |
