SPECIFICATIONS FOR PARTICULAR TYPES OF WINDING WIRES - PART 0-10: GENERAL REQUIREMENTS - POLYESTER GLASS-FIBRE WOUND FUSED, UNVARNISHED, OR RESIN OR VARNISH IMPREGNATED, BARE OR ENAMELLED ROUND COPPER WIRE
International Electrotechnical Committee
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms, definitions, general notes and appearance
4 Dimensions
5 Electrical resistance
6 Elongation
7 Springiness
8 Flexibility and adherence
9 Heat shock
10 Cut-through
11 Resistance to abrasion
12 Resistance to solvents
13 Breakdown voltage
14 Continuity of insulation
15 Temperature index
16 Resistance to refrigerants
17 Solderability
18 Heat or solvent bonding
19 Dielectric dissipation factor
20 Resistance to transformer oil
21 Loss of mass
23 Pin hole test
30 Packaging
Annex A (informative) - Diameters for intermediate
nominal conductor diameters (R40)
Annex B (informative) - Resistance
Annex C (informative) - High temperature failure
Bibliography
Describes the general requirements of polyester glass-fibre wound fused, unvarnished, or resin or varnish impregnated bare, grade 1 or grade 2 or enamelled round copper winding wires.
| Document Type | Standard |
| Status | Current |
| Publisher | International Electrotechnical Committee |
| Committee | TC 55 |
