TESTS FOR ELECTRIC CABLES UNDER FIRE CONDITIONS - CIRCUIT INTEGRITY - PART 2: TEST METHOD FOR FIRE WITH SHOCK AT A TEMPERATURE OF AT LEAST 830 DEGREES C FOR CABLES OF RATED VOLTAGE UP TO AND INCLUDING 0,6/1,0 KV AND WITH AN OVERALL DIAMETER NOT EXCEEDING 20MM
International Electrotechnical Committee
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Test environment
5 Test apparatus
6 Test specimen (electric power and control cables
with rated voltage up to and including
600 V/1000 V)
7 Test procedure (electric power and control cables
with rated voltage up to and including 600 V/1000 V)
8 Performance requirements (electric power and control
cables with rated voltage up to and including 600 V/1000 V)
9 Retest procedure
10 Test report (electric power and control cables with rated
voltage up to and including 600 V/1000 V)
11 Cable marking
Annex A (normative) - Verification procedure for the source
of heat
Annex B (informative) - Guidance on the choice of
recommended test apparatus
Bibliography
Describes the test method for cables which are required to maintain circuit integrity when subject to fire and mechanical shock under specified conditions.
| Document Type | Standard |
| Status | Current |
| Publisher | International Electrotechnical Committee |
| Committee | TC 20 |
