AS/NZS 1867:1997

Table of Contents

1 -  AS/NZS 1867:1997 ALUMINIUM AND ALUMINIUM ALLOYS - DRAWN TUBES
4 -  PREFACE
5 -  CONTENTS
6 -  SECTION 1 SCOPE AND GENERAL
6 -  1.1 SCOPE
6 -  1.2 REFERENCED DOCUMENTS
6 -  1.3 DEFINITIONS
6 -  1.3.1 Batch
6 -  1.3.2 Drawn tube
6 -  1.4 DESIGNATION
6 -  1.4.1 General
7 -  1.4.2 Alloy designation
7 -  1.4.3 Temper designation
7 -  1.5 ROUNDING OF TEST RESULT VALUES
7 -  1.6 MARKING
7 -  1.7 TRACEABILITY
8 -  SECTION 2 MANUFACTURING REQUIREMENTS
8 -  2.1 SCOPE
8 -  2.2 CHEMICAL COMPOSITION
8 -  2.2.1 General
8 -  2.2.2 Chemical analysis
8 -  2.3 SURFACE FINISH
8 -  2.4 FREEDOM FROM DEFECTS
8 -  2.5 MECHANICAL PROPERTIES
8 -  2.6 DIMENSIONAL TOLERANCES
12 -  SECTION 3 MECHANICAL TESTING REQUIREMENTS
12 -  3.1 SCOPE
12 -  3.2 SAMPLING FOR MECHANICAL TESTING
12 -  3.3 SELECTION OF TENSILE TEST PIECES
12 -  3.4 TENSILE TEST
12 -  3.5 RETESTS
13 -  SECTION 4 MANUFACTURING TOLERANCES
13 -  4.1 SCOPE
13 -  4.2 DIMENSIONAL TOLERANCE REQUIREMENTS
19 -  APPENDIX A - PURCHASING GUIDELINES
19 -  A1 GENERAL
19 -  A2 INFORMATION TO BE SUPPLIED BY THE PURCHASER
19 -  A3 SUPPLEMENTARY TEST REQUIREMENTS
20 -  APPENDIX B - TYPICAL FABRICATION CHARACTERISTICS AND APPLICATION DATA

Abstract

Specifies requirements for wrought aluminium and aluminium alloy drawn tube for general engineering purposes. Chemical composition and tensile properties are specified, and allowable tolerances on dimensions included. Included are two appendices, one provides guidelines on information to be supplied by the purchaser at the time of enquiry or order, the other lists fabrication characteristics and application data.

Scope

SCOPE This Standard specifies requirements for wrought aluminium and aluminium alloy drawn tube for general engineering purposes.
NOTES:
1 Advice and recommendations on information to be supplied by the purchaser at the time of enquiry or order are contained in the purchasing guidelines set out in Appendix A.
2 Typical fabrication characteristics and application data for wrought aluminium and aluminium alloys are given in Appendix B.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
Pages
ISBN
Committee	MT-003
Supersedes	DR 96327 AS 1867-1986