AS/NZS 3750.14:1997 (R2013)
AS/NZS 3750.14:1997 (R2013)
Paints for steel structures High-build epoxy (two-pack)
Standards Australia
Specials
-
-
JIS K 2247-1:2009
$78.00 (-56%) $34.32
Table of Contents
Abstract
Provides requirements for a two-component, high-build epoxy paint intended to be used for the protection of iron and steel against exterior atmospheric corrosion.
RECONFIRMATION NOTICE
Technical Committee CH-003 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 30 May 2013.
Approved for reconfirmation in New Zealand on behalf of the Standards Council of New Zealand on 26 August 2013.
The following are represented on Technical Committee CH-003:
Australasian Corrosion Association
Australian Paint Approval Scheme
Australian Paint Manufactures' Federation
Australian Pipeline Industry Association
Institution of Professional Engineers New Zealand
Master Painters New Zealand Association
Water Corporation Western Australia
Scope
This Standard specifies requirements for a two-component, high-build epoxy paint intended to be used for the protection of iron and steel against exterior atmospheric corrosion. It is intended primarily for paints applied by spraying (conventional pressure pot or airless). Paints specified in this Standard are described in AS/NZS 2312 as Paint Reference 13. This paint may be produced in a range of colours and may be pigmented with micaceous iron oxide pigments.
This Standard is applicable to paints intended for the protection of iron and steel against corrosion in damp and wet areas, and in those involving high humidity, coastal/marine and industrial fallout. It may be used as-
(a) high-build, single coat or multicoat finish; or
(b) intermediate, high-build coating under full-gloss epoxy paint complying with AS/NZS 3750.10 or full-gloss polyurethane paint complying with AS/NZS 3750.6.
NOTES:
1 This paint may be used with the appropriate primer in the following systems of AS/NZS 2312: MP5 -A, B, D, E, F, H, I, J, K; MP9 - A, B, C; LP1- A, E, I; LP2- A, C, D, F; LP4 -A, LP6 -A, B, GZLP - C, F, MSALP - C, MSZLP -C, and as one-coat protection in system MP1 - C and GZLP - C, F.
2 Appendix A contains recommendations and advice on information which should be provided by the purchaser at the time of enquiry or order.
3 Additional information on the use and application of high-build epoxy paints is contained in Appendix B.
4 Alternative methods for determining compliance with this Standard are given in Appendix C.
General Product Information
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmation Notice 16-09-2013 |
| Committee | CH-003 |
| Supersedes |
|
