AS 1141.50-1998 (R2016)
AS 1141.50-1998 (R2016)
Methods for sampling and testing aggregates Resistance to stripping of cover aggregates from binders
Standards Australia
Specials
-
-
JIS K 8034:2006
$78.00 (-56%) $34.32
Table of Contents
<toc />
Abstract
RECONFIRMATION NOTICE
Technical Committee CE-012 has reviewed the content of this publication and in
accordance with Standards Australia procedures for reconfirmation, it has been
determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the
original date of publication. Users are advised to ensure that they are using the latest
versions of such documents as appropriate, unless advised otherwise in this
Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for
reconfirmation on 29 June 2016.
The following are represented on Technical Committee CE-012:
ARRB Group - Australian Road Research Board
Australasian (iron & steel) Slag Association
Australasian Procurement and Construction Council
Australian Asphalt Pavement Association
Australian Geomechanics Society
AUSTROADS
Cement Concrete & Aggregates Australia – Aggregates
Cement Concrete & Aggregates Australia – Cement
Cement Concrete & Aggregates Australia – Concrete
Engineering & Construction Laboratories Association
National Association of Testing Authorities Australia
Rail Industry Safety and Standards Board
The Institute of Quarrying Australia
Scope
This Standard sets out the method for the preparation, curing and assessment of resistance to stripping of cover aggregates from bituminous binders in the presence of water. This method may be used for various combinations of aggregate and binders with or without the use of precoated materials or adhesion agents.
The assessment is based on visual inspection of the particles after their removal from a binder which is cured on metal plates under standard conditions. It is not applicable to aggregate particles greater than 20 mm or less than 9.5 mm.
General Product Information
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmed 22/07/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 22/07/2016 |
| Committee | CE-012 |
| Supersedes |
|
