Methods of testing concrete Determination of mass per unit volume of hardened concrete - Rapid measuring method
Standards Australia
RECONFIRMATION NOTICE
Technical Committee BD-042 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 9 September 2014.
The following are represented on Technical Committee BD-042:
AUSTROADS
Australian Chamber of Commerce and Industry
Cement Concrete and Aggregates—Concrete
Concrete Institute of Australia
National Association of Testing Authorities Australia
The University of New South Wales
University of Technology Sydney
Victorian Construction Materials Laboratory
This Standard sets out a rapid method for determining the mass per unit volume of hardened concrete consisting of regular shaped specimens with a minimum of defects. This Method is also applicable to capped specimens, provided the mass per unit volume of the cap does not differ from that of the specimen by more than 25 percent.
NOTES:
1 Because of possible variation in results, it is envisaged that the mass per unit volume of concrete should be based on the average value determined from a group of at least two representative specimens.
2 For general procedures and precautions designed to promote safety of persons and property in laboratory operations (see AS/NZS 2243.1 - list in Referenced Documents).
3 This Standard may involve hazardous materials, operations, and equipment. This Standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this Standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmed 24/10/2014. This standard has been reconfirmed in Australia in 2014 and remains current in New Zealand. Reconfirmation Notice 24/10/2014 |
| Committee | BD-042 |
| Supersedes |
|
