AS 1141.4-2000 (R2013)
AS 1141.4-2000 (R2013)
Methods for sampling and testing aggregates Bulk density of aggregate
Standards Australia
Specials
-
-
IEC 61156-4 : 3.0
$78.00 (-56%) $34.32
Abstract
RECONFIRMATION NOTICE
Technical Committee CE-012 has reviewed the content of this publication and in accordance
with Standards Australia procedures for reconfirmation, it has been determined that the
publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original
date of publication. Users are advised to ensure that they are using the latest versions of
such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for
reconfirmation on 5 December 2013.
Approved for reconfirmation in New Zealand on behalf of the Standards Council of
New Zealand on .
The following are represented on Technical Committee CE-012:
ARRB Group Ltd
Ash Development Association of Australia
Australasian Procurement and Construction Council
Australasian Railway Association
Australasian Slag Association
Australian Asphalt Pavement Association Limited
Australian Chamber of Commerce and Industry
Australian Geomechanics Society
Australian Local Government Association
AUSTROADS
Bureau of Steel Manufacturers of Australia
Cement Concrete and Aggregates Australia
Engineering and Construction Laboratories Association
National Association of Testing Authorities Australia
The Institute of Quarrying Australia
Scope
This Standard sets out the method for determining the bulk density of fine, coarse, or mixed aggregates. The bulk density is determined in the uncompacted, compacted, or uncompacted and compacted states.
The test is normally performed on material dried to constant mass, but may be performed at other moisture conditions if specifically required. The values obtained for bulk density of fine aggregates at different moisture conditions will differ significantly.
This method is only applicable to samples with a maximum nominal size of 63 mm.
General Product Information
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | This standard has been reconfirmed in Australia in 2013 and remains current in New Zealand. Reconfirmation Notice 16-01-2014 |
| Committee | CE-012 |
| Under Revision |
|
| Supersedes |
|
