AS 2331.1.5-2001 (R2017)

Table of Contents

Abstract

Sets out a method for the non-destructive measurement of coating thickness using beta-backscatter gauges. Applies to both metallic and non-metallic coatings on both metallic and non-metallic substrates.
RECONFIRMATION NOTICE
Technical Committee MT-009 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 20 March 2017.
The following are represented on Technical Committee MT-009:
Australasian Institute of Surface Finishing
Australian Chamber of Commerce and Industry
Australian Industry Group
Australian Steel Institute
Bureau of Steel Manufacturers of Australia
Galvanizers Association of Australia
Galvanizing Association of New Zealand
New Zealand Metal Roofing Manufacturers

Scope

This Standard specifies a method for the non-destructive measurement of coating thicknesses using beta-backscatter gauges. It applies to both metallic and non-metallic coatings on both metallic and non-metallic substrates. To employ this method, the atomic numbers or equivalent atomic numbers of the coating and the substrate need to differ by an appropriate amount.
WARNING: BETA-BACKSCATTER INSTRUMENTS USED FOR THE MEASUREMENT OF COATING THICKNESSES EMPLOY A NUMBER OF DIFFERENT RADIOACTIVE SOURCES. ALTHOUGH THE ACTIVITIES OF THESE SOURCES ARE NORMALLY VERY LOW, THEY CAN PRESENT A HAZARD TO HEALTH, IF INCORRECTLY HANDLED. THEREFORE, ALL RULES AND REGULATIONS OF LOCAL OR NATIONAL AUTHORITIES MUST BE OBSERVED.
NOTES:
1 Characteristics of isotopes used with beta-backscatter gauges are given in Appendix A.
2 The atomic numbers of some commonly used coatings and substrates are given in Appendix B.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 07/04/2017. This standard has been reconfirmed in Australia in 2017 and remains current in New Zealand. Reconfirmation Notice 07/04/2017
Pages
ISBN
Committee	MT-009
Supersedes	DR 99372 AS 2331.1.5-1981 DR 99377