AS 3522.6-2002

Table of Contents

1 -  AS 3522.6-2002 IDENTIFICATION CARDS-RECORDING TECHNIQUE - MAGNETIC STRIPE-HIGH COERCIVITY
4 -  PREFACE
5 -  CONTENTS
7 -  1 Scope
7 -  2 Conformance
7 -  3 Normative references
8 -  4 Terms and definitions
8 -  4.1 primary standard
8 -  4.2 secondary standard
8 -  4.3 unused un-encoded card
8 -  4.4 unused encoded card
8 -  4.5 returned card
8 -  4.6 flux transition
8 -  4.7 reference current
8 -  4.8 reference flux level
8 -  4.9 test recording currents
9 -  4.10 individual signal amplitude
9 -  4.11 average signal amplitude
9 -  4.12 reference signal amplitude
9 -  4.13 physical recording density
9 -  4.14 bit density
9 -  4.15 bit cell
9 -  4.16 sub interval
9 -  4.17 demagnetisation current
9 -  5 Physical characteristics of the identification card
11 -  6 Physical characteristics of the magnetic stripe
11 -  6.1.1 Surface profile of the magnetic stripe area
13 -  6.1.2 Height of the magnetic stripe area
13 -  7 Performance characteristics for the magnetic material
13 -  7.1 General
13 -  7.2 Testing and operating environment
14 -  7.3 Signal amplitude requirements for magnetic media
16 -  8 Encoding technique
16 -  9 Encoding specification, general
18 -  10 Encoding specifications
18 -  10.1 Alphanumeric track, track 1
18 -  10.1.1 Average bit density
18 -  10.1.2 Flux transition spacing variation
19 -  10.1.3 Coded character set
20 -  10.1.4 Maximum number of characters for ID-1 type card
21 -  10.2 Numeric track, Track 2
21 -  10.2.1 Average bit density
21 -  10.2.2 Flux transition spacing variation
21 -  10.2.3 Coded character set
22 -  10.2.4 Maximum number of characters for ID-1 type card
22 -  10.3 Numeric track, Track 3
22 -  10.3.1 Average bit density
22 -  10.3.2 Flux transition spacing variation
22 -  10.3.3 Coded character set
23 -  10.3.4 Maximum number of characters for ID-1 type card
23 -  11 Error detection
23 -  11.1 Parity
23 -  11.2 Longitudinal redundancy check (LRC)
23 -  12 Location of encoded tracks
25 -  Annex A - Read compatibility of magnetic stripes (ISO/IEC 7811-2 and ISO/IEC 7811-6)
26 -  Annex B - Signal amplitude measurements
27 -  Annex C - Magnetic stripe abrasivity
28 -  Annex D - Static magnetic characteristics
28 -  D.1 Introduction
28 -  D.2 Definitions
29 -  D.3 Recommended characteristics

Abstract

Specifies requirements for a high coercivity magnetic stripe on an ID card, the encoding technique and coded character sets

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Pending Revision indicates that as a result of the Aged Standards review process, the document needs updating. If no project proposal, meeting the quality criteria, is received within the 12 month timeframe, the document shall be withdrawn.
Pages
ISBN
Committee	IT-012
Supersedes	DR 01217 CP