AS 3894.5-2002 (R2013)

Table of Contents

1 -  AS 3894.5-2002 SITE TESTING OF PROTECTIVE COATINGS - DETERMINATION OF SURFACE PROFILE
1 -  PREFACE
1 -  FOREWORD
1 -  METHOD
1 -  1 SCOPE
2 -  2 REFERENCED DOCUMENTS
2 -  3 DEFINITIONS
2 -  3.1 Surface profile
2 -  4 GENERAL
2 -  4.1 Choice of method
2 -  4.2 Preliminary work
2 -  4.3 Low profile measurements
3 -  4.4 Very coarse profile measurements
3 -  4.5 Sampling procedure
3 -  5 METHOD A-PROFILE REPLICATING TAPE
3 -  5.1 Principle
3 -  5.2 Equipment
3 -  5.2.1 Profile replicating tape
3 -  5.2.2 Burnishing tool
4 -  5.2.3 Spring-loaded micrometer
4 -  5.3 Procedure
4 -  5.4 Report
4 -  6 METHOD B - PROFILE COMPARATOR
4 -  6.1 Principle
4 -  6.2 Equipment
4 -  6.2.1 Profile comparator
4 -  6.2.2 Viewing instrument
5 -  6.3 Procedure
5 -  6.4 Report
5 -  7 METHOD C - NEEDLE-TYPE DEPTH MICROMETER
5 -  7.1 Principle
5 -  7.2 Equipment
6 -  7.3 Procedure
6 -  7.4 Report
6 -  8 METHOD D - MAGNETIC-TYPE THICKNESS GAUGE
6 -  8.1 Principle
6 -  8.2 Equipment
7 -  8.3 Procedure
7 -  8.4 Report

Abstract

Technical Committee CH-003 has reviewed the content of this publication and in
accordance with Standards Australia procedures for reconfirmation, it has been determined
that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original
date of publication. Users are advised to ensure that they are using the latest versions of
such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for
reconfirmation on 25 September 2013.
The following are represented on Technical Committee CH-003:
Australasian Corrosion Association
Australian Paint Approval Scheme
Australian Paint Manufacturers' Federation
Australian Pipeline Industry Association
Water Corporation Western Australia

Scope

This Standard provides practical procedures for use in the field, to evaluate the surface profile of a prepared metal substrate to which a protective coating is to be applied.

This Method is applicable to surfaces that have been prepared by abrasive blast cleaning in accordance with AS 1627.4.

Four methods are described for assessing surface profile.

NOTES:
1 Results obtained using different methods are not necessarily comparable.
2 Surface profile does not play any part in surface cleanliness.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmation Notice 12/11/2013
Pages
ISBN
Committee	CH-003
Supersedes	AS/NZS 3894.5:1995 DR 01384-01397 CP DR 01389 CP