AS 3715-2002 (R2017)
AS 3715-2002 (R2017)
Metal finishing - Thermoset powder coating for architectural applications of aluminium and aluminium alloys
Standards Australia
Specials
-
-
IEC 60489-6 : 3.0
$78.00 (-56%) $34.32
Table of Contents
Abstract
Sets out test procedures and specifies performance requirements for thermoset powder coatings applied to aluminium and aluminium-alloy substrates intended for architectural applications and welded areas.
RECONFIRMATION NOTICE
Technical Committee MT-009 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 20 March 2017.
The following are represented on Technical Committee MT-009:
Australasian Institute of Surface Finishing
Australian Chamber of Commerce and Industry
Australian Industry Group
Australian Steel Institute
Bureau of Steel Manufacturers of Australia
Galvanizers Association of Australia
Galvanizing Association of New Zealand
New Zealand Metal Roofing Manufacturers
Scope
This Standard sets out test procedures and specifies performance requirements for thermoset powder coatings applied to aluminium and aluminium-alloy substrates intended for architectural applications.
This Standard applies only to thermoset powder coatings for exterior architectural uses.
NOTES:
1 Appendix A contains advice and recommendations on information which should be supplied by the purchaser at the time of enquiry or order.
2 Information on weathering performance of powder-coated aluminium products is given in Appendix B.
3 Information on maintenance and repair of coatings is given in Appendix C.
4 Advice on handling and temporary protection during transportation and installation is given in Appendix D.
General Product Information
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmed 07/04/2017. This standard has been reconfirmed in Australia in 2017 and remains current in New Zealand. Reconfirmation Notice 07/04/2017 |
| Committee | MT-009 |
| Supersedes |
|
