Determination of particle size distribution by centrifugal liquid sedimentation methods General principles and guidelines
Standards Australia
Sets out methods for determining the particle size distributions of particulate materials, typically in the size range 0.1 µm to 5 µm, by centrifugal sedimentation in a liquid. The methods of determining the particle size distribution described in this part of ISO 13318 are applicable to slurries, particulate materials which can be dispersed in liquids and some emulsions. A positive density difference between the discrete and continuous phases is necessary, although centrifugal photosedimentation can be used for emulsions where the droplets are less dense than the liquid in which they are dispersed. This Standard is identical with and has been reproduced from ISO 13318-1:2001.
RECONFIRMATION NOTICE
Technical Committee NT-001 has reviewed the content of this publication and in
accordance with Standards Australia procedures for reconfirmation, it has been
determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the
original date of publication. Users are advised to ensure that they are using the latest
versions of such documents as appropriate, unless advised otherwise in this
Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for
reconfirmation on 9 September 2016.
The following are represented on Technical Committee NT-001:
Accord Australasia
Australasian College of Toxicology & Risk Assessment
Australian Industry Group
Australian Solar Council
Consumers Federation of Australia
CSIRO
Engineers Australia
National Association of Testing Authorities Australia
National Industrial Chemical Notification and Assessment Scheme
National Measurement Institute
Safe Work Australia
Safety Institute of Australia
University of Adelaide
This part of ISO 13318 covers methods for determining the particle size distributions of particulate materials, typically in the size range 0,1 µm to 5 µm, by centrifugal sedimentation in a liquid.
NOTE This part of ISO 13318 may involve the use of hazardous materials operations and equipment. This part of ISO 13318 does not purport to address all the safety problems associated with its use. It is the responsibility of the user of this part of ISO 13318 to establish appropriate safety and health practices and to determine the applicability of the regulatory limitations prior to its use.
The methods of determining the particle size distribution described in this part of ISO 13318 are applicable to slurries, particulate materials which can be dispersed in liquids and some emulsions. A positive density difference between the discrete and continuous phases is necessary, although centrifugal hotosedimentation can be used for emulsions where the droplets are less dense than the liquid in which they are dispersed.
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmed 23/09/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 23/09/2016 |
| Committee | CH-032 |
| Supersedes |
|
