AS 60068.2.78-2003 (R2018)

Table of Contents

1 -  AS 60068.2.78-2003 ENVIRONMENTAL TESTING - TESTS-TEST Cab: DAMP HEAT, STEADY STATE
4 -  PREFACE
5 -  CONTENTS
7 -  1 Scope
7 -  2 Normative references
7 -  3 General description
8 -  4 Test chamber
8 -  4.1 Testing of heat-dissipating specimens
8 -  4.2 Mounting of the specimens
8 -  5 Severity
9 -  6 Initial measurements
9 -  7 Conditioning
9 -  8 Intermediate measurements
9 -  9 Recovery
10 -  10 Final measurements
10 -  11 Information to be given in the relevant specification

Abstract

Provides a test method for determining the suitability of
electrotechnical products, components or equipment for
transportation, storage and use under conditions of high
humidity.

RECONFIRMATION NOTICE
Major stakeholders of this publication have reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 29 August 2018.

Scope

This part of IEC 60068 provides a test method for determining the suitability of electrotechnical products, components or equipment for transportation, storage and use under conditions of high humidity. The test is primarily intended to permit the observation of the effect of high humidity at constant temperature without condensation on the specimen over a prescribed period.
This test provides a number of preferred severities of high temperature, high humidity and test duration. The test can be applied to both heat-dissipating and non-heat dissipating specimens.
The test is applicable to small equipment or components as well as large equipment having complex interconnections with test equipment external to the chamber, requiring a set-up time which prevents the use of preheating and the maintenance of specified conditions during the installation period.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmation Notice 14/09/2018 Reconfirmed 14/09/2018. This standard has been reconfirmed in Australia in 2018 and remains current in New Zealand.
Pages
ISBN
Committee	EL-026
Supersedes	DR 03399-03413 CP DR 03413 CP AS 1099.2.3-1990