AS 1192-2004 (R2017)

Table of Contents

<toc />

Abstract

Specifies the requirements for electroplated coatings of nickel and nickel plus chromium on steel or iron, zinc alloy, copper or copper alloy, aluminium or aluminium alloys.
RECONFIRMATION NOTICE
Technical Committee MT-009 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 20 March 2017.
The following are represented on Technical Committee MT-009:
Australasian Institute of Surface Finishing
Australian Chamber of Commerce and Industry
Australian Industry Group
Australian Steel Institute
Bureau of Steel Manufacturers of Australia
Galvanizers Association of Australia
Galvanizing Association of New Zealand
New Zealand Metal Roofing Manufacturers

Scope

This Standard specifies requirements for electroplated coatings of nickel and nickel plus chromium on steel or iron, zinc alloy, copper or copper alloy, aluminium or aluminium alloys. It also specifies requirements for coatings of nickel-iron alloys containing a maximum iron content of 25 percent, and coatings incorporating a copper undercoat. It does not preclude the use of gold, copper, brass or other metals plated over nickel.
This Standard does not apply to the following:
(a) Coatings applied to screw threads (with tolerances).
(b) Coatings applied to sheet, strip or wire in the unfabricated form, or to coil springs.
(c) Coatings applied as an undercoat to hard chromium coatings for engineering applications, see AS 2453.
(d) Coatings applied to plastics, see AS 1406.
Supplementary information to be supplied with the enquiry or order is specified in Appendix A.
NOTE: The means for demonstrating compliance with the Standard are shown in Appendix B.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 07/04/2017. This standard has been reconfirmed in Australia in 2017 and remains current in New Zealand. Reconfirmation Notice 07/04/2017
Pages
ISBN
Committee	MT-009
Supersedes	AS 1192-1982 DR 03465