AS 4563-2004 (R2016)
AS 4563-2004 (R2016)
Commercial catering gas equipment
Standards Australia
Specials
-
-
IEC 60695-10-2 : 3.0 : 2014
$78.00 (-56%) $34.32
Table of Contents
Abstract
Specifies the uniform minimum requirements for manufacturers, designers, regulatory authorities, testing laboratories and similar organizations for the safety, performance and use of various types of commercial catering equipment intended for use with natural gas, town gas, liquefied petroleum gas and tempered liquefied petroleum gas.
RECONFIRMATION NOTICE
Technical Committee AG-001 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 25 September 2015.
The following are represented on Technical Committee AG-001:
Association of Accredited Certification Bodies
Australian Building Codes Board
Consumer Electronics Suppliers Association
Consumers Federation of Australia
Energy Efficiency and Conservation Authority of New Zealand
Energy Networks Association
Gas Appliance Manufacturers Association of Australia
Gas Association of New Zealand
Gas Energy Australia
Gas Technical Regulators Committee
Gas Utilisation Institute, New Zealand
The Australian Gas Association
Worksafe—Energy Safety New Zealand
Scope
This Standard applies to various types of commercial catering equipment intended for use with natural gas, town gas, liquefied petroleum gas and tempered liquefied petroleum gas.
NOTE: Other statutory and regulatory requirements may be applicable to the product(s) that fall within the scope of this standard. It is the manufacturer’s, importer’s or distributor’s responsibility (as appropriate) to ensure that products comply with such requirements.
General Product Information
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmed 27/05/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 27/05/2016 |
| Committee | AG-001 |
| Supersedes |
|
