AS 2505.2-2004 (R2017)

Table of Contents

Abstract

Specifies methods for simple and reverse bend testing in the longitudinal direction of coated and uncoated metal bars, rods, and solid shapes.
RECONFIRMATION NOTICE
Technical Committee MT-009 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 20 March 2017.
The following are represented on Technical Committee MT-009:
Australasian Institute of Surface Finishing
Australian Chamber of Commerce and Industry
Australian Industry Group
Australian Steel Institute
Bureau of Steel Manufacturers of Australia
Galvanizers Association of Australia
Galvanizing Association of New Zealand
New Zealand Metal Roofing Manufacturers

Scope

This Standard specifies methods for simple and reverse bend testing in the longitudinal direction of coated and uncoated metal bars, rods and solid shapes.
NOTES:
1 Criteria for assessment of the results of tests are not included; they are specified in appropriate product Standards.
2 Where angles of bend of test pieces are specified in product Standards, they are deemed to be minimum angles. However, where radii of bends of mandrels or formers are specified, they are deemed to be maximum radii.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 31/03/2017. This standard has been reconfirmed in Australia in 2017 and remains current in New Zealand. Reconfirmation Notice 31/03/2017
Pages
ISBN
Committee	MT-006
Supersedes	AS 2505.2-1989 DR 04302