AS/NZS 60695.11.5:2005

Table of Contents

1 -  AS/NZS 60695.11.5 Fire hazard testing - Part 11.5: Test flames-Needle-flame test method-Apparatus, confirmatory test arrangem
4 -  CONTENTS
5 -  PREFACE
6 -  INTRODUCTION
7 -  1 Scope
7 -  2 Normative references
7 -  3 Terms and definitions
8 -  4 General description of the test
8 -  5 Description of the test apparatus
8 -  5.1 Burner
8 -  5.2 Flame
8 -  5.3 Laboratory fumehood/chamber
9 -  5.4 Specified layer
9 -  5.5 Timing device
9 -  6 Test specimen
10 -  7 Severities
10 -  8 Conditioning
10 -  9 Test procedure
10 -  9.1 Position of test specimen
10 -  9.2 Application of needle-flame
10 -  9.3 Number of test specimens
11 -  10 Observations and measurements
11 -  11 Evaluation of test results
11 -  12 Information to be given in the relevant specification
12 -  13 Test report
14 -  Annex A (normative) Confirmatory test arrangement
14 -  A.1 Confirmation of the test flame – Principle
14 -  A.2 Test apparatus
14 -  A.2.1 Burner
14 -  A.2.2 Control valve
14 -  A.2.3 Copper block
14 -  A.2.4 Thermocouple
14 -  A.2.5 Temperature indicating, recording and timing devices
14 -  A.3 Procedure
19 -  Annex B (informative) Access to equipment manufacturers and suppliers
20 -  Bibliography

Abstract

Specifies a needle-flame test to simulate the effect of a small flame which may result from fault conditions, in order to assess by a simulation technique the fire hazard. It is applicable to electrotechnical equipment, its sub-assemblies and components and to solid electrical insulating materials or other combustible materials.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
Pages
ISBN
Committee	EL-002
Supersedes	DR 05917 CP AS/NZS 4695.2.2:1996