AS 4256.2-2006 (R2018)

Table of Contents

1 -  AS 4256.2-2006 PLASTIC ROOF AND WALL CLADDING MATERIALS - UNPLASTICIZED POLYVINYL CHLORIDE (UPVC) BUILDING SHEETS
4 -  PREFACE
5 -  CONTENTS
6 -  1 SCOPE
6 -  2 REFERENCED DOCUMENTS
7 -  3 DEFINITIONS
7 -  4 CLASSIFICATION
7 -  4.1 Class
7 -  4.2 Type
7 -  5 WORKMANSHIP
7 -  6 DIMENSIONAL REQUIREMENTS
7 -  6.1 Tolerances on nominated length, width and cover width
7 -  6.2 Thickness
7 -  6.3 Squareness
8 -  6.4 Profile
8 -  7 DURABILITY
8 -  8 TEST REQUIREMENTS
8 -  8.1 Light transmission (applicable only to translucent and transparent sheets)
8 -  8.2 Impact resistance
8 -  8.3 Tensile strength
9 -  8.4 Colourfastness and impact resistance following ultraviolet light exposure
9 -  9 MARKING
10 -  APPENDIX A - MEANS FOR DEMONSTRATING COMPLIANCE WITH THIS STANDARD
10 -  A1 SCOPE
10 -  A2 STATISTICAL SAMPLING
10 -  A3 PRODUCT CERTIFICATION
11 -  A4 SUPPLIER'S QUALITY MANAGEMENT SYSTEM
11 -  A5 OTHER MEANS OF ASSESSMENT

Abstract

Specifies requirements for transparent, translucent and opaque, uncoated and coated uPVC sheets that are formed into profiles and are primarily intended for use as a roof cladding sheets.

RECONFIRMATION NOTICE
Major stakeholders of this publication have reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 29 August 2018.

Scope

This Standard specifies requirements for transparent, translucent and opaque, uncoated and coated uPVC sheets that are formed into profiles and primarily intended for use as roof cladding sheet. In certain circumstances, the same material may be used as a wall cladding sheet. It applies to uPVC sheeting installed in accordance with AS 1562.3.
NOTE: Means for demonstrating compliance with this Standard are given in Appendix A.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 21/09/2018. This standard has been reconfirmed in Australia in 2018 and remains current in New Zealand. Reconfirmation Notice 21/09/2018
Pages
ISBN
Committee	PL-022
Supersedes	AS/NZS 4256.2:1994 DR 03154