AS 3785.7-2006

Table of Contents

1 -  AS 3785.7-2006 UNDERGROUND MINING-SHAFT EQUIPMENT - SHEAVES
4 -  PREFACE
5 -  CONTENTS
6 -  1 SCOPE
6 -  2 REFERENCED DOCUMENTS
7 -  3 DEFINITIONS
7 -  3.1 Conveyance
7 -  3.2 Conveyance rated load
7 -  3.3 Dead load
7 -  3.4 Design rope break load
7 -  3.5 Design working life
7 -  3.6 Fleet angle
7 -  3.7 Insert
7 -  3.8 Live load
7 -  3.9 Rope break load
7 -  3.10 Shall
8 -  3.11 Sheave
8 -  3.12 Should
8 -  3.13 Statutory authority
8 -  3.14 Winding rope
8 -  3.15 Wrap angle
8 -  4 MATERIALS
8 -  5 MANUFACTURE
9 -  6 DESIGN
9 -  6.1 Loads
9 -  6.2 Load combination
9 -  6.2.1 Static design
9 -  6.2.2 Fatigue design
9 -  6.3 Design criteria
9 -  6.3.1 Rim, spoke, web and hub (including connections)
10 -  6.3.2 Shafts
10 -  6.3.3 Bearings
10 -  6.3.4 Construction design
11 -  7 NON-DESTRUCTIVE TESTING
11 -  8 TEST CERTIFICATES
11 -  8.1 Certificates required
12 -  9 MARKING
13 -  APPENDIX A - INFORMATION TO BE PROVIDED BY THE PURCHASER
14 -  APPENDIX B - INFORMATION TO BE PROVIDED BY THE SUPPLIER
15 -  APPENDIX C - SHEAVE RIM DIMENSIONAL PROPORTIONS
15 -  C1 SCOPE
15 -  C2 SHEAVE RIMS WITHOUT INSERTS
15 -  C3 SHEAVE RIMS WITH INSERTS
15 -  C4 SHEAVE GROOVE DIMENSIONS
18 -  APPENDIX D - TREAD PRESSURE BETWEEN ROPE AND SHEAVE
18 -  D1 SCOPE
18 -  D2 TREAD PRESSURE DESIGN BASIS
20 -  APPENDIX E - SHEAVE DIAMETER
21 -  APPENDIX F - ALLOWABLE WEAR FOR SHEAVE RIMS WITHOUT INSERTS

Abstract

Sets out requirements for sheaves in mine winding systems. Covers materials, manufacture, design, non-destructive testing and marking. Appendices provide information on rim dimensional proportions, surface stress between rope and sheave, sheave diameter and allowable wear for sheave rims without inserts.

Scope

This Standard specifies requirements for sheaves manufactured from ferrous materials used in mine winding systems. This Standard does not apply to drive pulleys used in friction winder installations.
NOTES:
1 Information to be provided by the purchaser is given in Appendix A.
2 Information to be provided by the supplier is given in Appendix B.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Pending Revision indicates that as a result of the Aged Standards review process, the document needs updating. If no project proposal, meeting the quality criteria, is received within the 12 month timeframe, the document shall be withdrawn.
Pages
ISBN
Committee	ME-018
Supersedes	AS 3785.7-1993 DR 05511 CP