Wrought alloy steels - Standard, hardenability (H) series and hardened and tempered to designated mechanical properties
Standards Australia
Specifies requirements for wrought alloy steels intended for general engineering purposes and is applicable to hot-rolled or cold-finished bars for machines, booms, billets and slabs for forgings, and forgings.
RECONFIRMATION NOTICE
Technical Committee MT-001 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 04 June 2017.
The following are represented on Technical Committee MT-001:
Australian Building Codes Board
Australian Steel Association
Australian Steel Institute
Bureau of Steel Manufacturers of Australia
Employers and Manufacturers Association
Materials Australia
New Zealand Heavy Engineering Research Association
Society of Automotive Engineers- Australasia
This Standard specifies requirements for wrought alloy steels intended for general engineering purposes and is applicable to hot-rolled or cold-finished bars for machining, blooms, billets and slabs for forgings, and forgings, as follows:
(a) To specified chemical composition only (standard steel series).
(b) To specified chemical composition and end-quench hardenability requirements (H series).
(c) To specified chemical composition and mechanical properties achieved by hardening and tempering.
This Standard does not apply to stainless steels.
NOTES:
1 Advice and recommendations on information to be supplied by the purchaser at the time of enquiry or order are contained in Appendix A.
2 Alternative means for determining compliance with this Standard are given in Appendix B.
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmed 07/07/2017. This standard has been reconfirmed in Australia in 2017 and remains current in New Zealand. Reconfirmation Notice 07/07/2017 |
| Committee | MT-001 |
| Supersedes |
|
