AS 60060.3-2008

Table of Contents

1 -  AS 60060.3-2008 High-voltage test techniques - Part 3: Definitions and requirements for on-site testing
4 -  PREFACE
5 -  CONTENTS
7 -  INTRODUCTION
9 -  1 Scope
9 -  2 Normative references
10 -  3 Terms and definitions
14 -  4 Common tests and checks on a measuring system
14 -  4.1 Acceptance test
14 -  4.2 Performance test
15 -  4.3 Performance check
15 -  4.4 Record of performance
15 -  5 Tests with direct voltage
15 -  5.1 General
15 -  5.2 Definitions for direct voltage tests
16 -  5.3 Test voltage
16 -  5.4 Measurement of the test voltage
17 -  5.5 Tests and checks on measuring systems
17 -  5.6 Withstand voltage test procedure
17 -  6 Tests with alternating voltage
17 -  6.1 General
18 -  6.2 Definitions for alternating voltage tests
18 -  6.3 Test voltage
19 -  6.4 Measurement of the test voltage
20 -  6.5 Tests and checks on measuring systems
20 -  6.6 Withstand voltage test procedure
20 -  7 Tests with lightning impulse voltage
20 -  7.1 General
20 -  7.2 Definitions for lightning impulse voltage tests
23 -  7.3 Test voltage
23 -  7.4 Measurement of the test voltage and determination of the impulse voltage shape
24 -  7.5 Tests and checks on measuring systems
24 -  7.6 Withstand voltage test procedures
25 -  8 Tests with switching impulse voltage
25 -  8.1 General
25 -  8.2 Definitions for switching impulse voltage tests
28 -  8.3 Test voltage
28 -  8.4 Measurement of the test voltage and determination of the impulse shape
29 -  8.5 Tests and checks on measuring systems
29 -  8.6 Withstand voltage test procedures
30 -  9 Tests with very low frequency voltages
30 -  9.1 General
30 -  9.2 Definitions for very low frequency voltage tests
30 -  9.3 Test voltage
31 -  9.4 Measurement of the test voltage
32 -  9.5 Tests and checks on measuring systems
32 -  9.6 Test procedure
32 -  10 Tests with damped alternating voltages
32 -  10.1 General
32 -  10.2 Definitions for damped alternating voltage tests
33 -  10.3 Test voltage
34 -  10.4 Measurement of the test voltage
34 -  10.5 Tests and checks on measuring systems
35 -  10.6 Test procedure

Abstract

Proposes requirements for on-site high-voltage tests with direct voltage, alternating voltage, lightning impulse voltage and switching impulse voltage on equipment with highest voltage greater than 1 kV.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Pending Revision indicates that as a result of the Aged Standards review process, the document needs updating. If no project proposal, meeting the quality criteria, is received within the 12 month timeframe, the document shall be withdrawn.
Pages
ISBN
Committee	EL-007
Supersedes	DR 07143 CP