AS 5200.458-2008 (R2016)

Table of Contents

<toc />

Abstract

RECONFIRMATION NOTICE
Technical Committee WS-001 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 3 September 2015.
The following are represented on Technical Committee WS-001:
Association of Accredited Certification Bodies
Australian Industry Group
Building Officials Institute of New Zealand
CSIRO
Gas Technical Regulators Committee
Housing Industry Association
National Association of Testing Authorities Australia
Plastics Industry Pipe Association of Australia
Plastics New Zealand
Plumbing Distributors Association of New Zealand
Plumbing Products Industry Group
Queensland Brassware Association
The Institute of Plumbing Australia
Water Services Association of Australia

Scope

This Standard sets out requirements for plastic-bodied transition couplings intended to join PE, PB, PEX, PP, PVC, ABS, copper, ductile iron, cast iron, lead, stainless steel and galvanized steel pipes for cold water applications (with a maximum operating pressure of 1250 kPa at 20°C) to each other and to themselves (i.e., PE to copper), for pipe/tube sizes up to 110 mm outside diameter.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 03/06/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 03/06/2016
Pages
ISBN
Committee	WS-001
Supersedes	DR 07437 ATS 5200.458-2004